Geothermal Earth Loops for West Chester

In part three of our Introduction to Geothermal series, we are going to talk about geothermal loop systems and how each type works.

A geothermal loop is the series of underground pipes used to transfer heat to and from the earth. These pipes are formed out of high-density polyethylene to create a reliable, long-lasting system. They are fastened together by the process of thermal fusion which will produce a bond that is far stronger than the original pipe itself. In fact, a properly installed loop can survive up to 200 years.
 
There are two main types of geothermal loop systems that are mostly used in today's installations: open loop systems and closed loop systems. Both systems have distinct pros and cons for your heating or cooling solution. We at Brandywine Valley Heating & Air Conditioning have the knowledge and experience on both types, and we will guide you step by step in the process of selecting the best option for your geothermal installation.

Open loop geothermal solutions are designed to utilize the natural groundwater from under your home. Using a well, water is from an existing aquifer and moved to the geothermal heat pump where its heat is taken out and the water is pumped back into the ground or to an assigned runoff. Since the water that you are using is not being altered in any way, the only thing that is being returned to the ground is water that is slightly warmer or cooler (depending whether you're in heating or cooling mode).

One consideration to keep an eye on with an open loop system is water quality. Mineral build-up can take place from poor quality water. This can be attended to with an occasional cleaning. If the water in the earth has higher iron content, you will need to make sure that the used water is kept away from air before it is returned in order to prevent clogs.
 
Closed loops are exactly as they sound. Instead of pumping water from a well and depositing it elsewhere, water is circulated in a entirely sealed circuit with a small amount of earth friendly antifreeze.
 
There are two main types of closed loop installations: horizontal and vertical. Putting in the system horizontally requires a good chunk of land. The piping is buried in trenches between 4 and 6 feet deep and can be up to 400 feet long. If you live on a smaller lot, the loops can be installed vertically by boring straight down using drilling equipment. This category of installation can be installed in as little as a 10ft by 10ft  area.
 
In either case, the bigger the building, the bigger the geothermal heat pump and loop needs to be. A good ball park figure is that for every ton of system capacity, you will need 500 to 600 feet of pipe.
 
Contact Brandywine Valley Heating & Air Conditioning today to learn more about what system choices are available to you here in West Chester.